1. Use a peice of masking tape on the top corners to position the decal in the desired location.

2. Apply a horizontal tape "hinge" along the top edge of the transfer paper and glass.

3. Lift the assembly from the bottom and slowly remove the back paper, leaving the transfer tape and decal.

4. Keeping the transfer tape tight, lower the transfer tape/decal and swipe squeegee pressure from the face of the transfer tape. Begin in the middle and rub outward (side to side) while slowly revealing/applying the decal to the glass.

5. Once the entire decal is affixed to the glass, take a second swipe over all, to ensure no air bubbles.

6. Allow a couple minutes for the vinyl adhesive to bond to the glass.

7. Remove the "hinge"

8. Slowly remove transfer tape by pulling the tape back over itself at a slight angle.

9. If any air pockets remain, use a needle to puncture through the face of the vinyl, releasing the air.